Do you know how Dingli wood shaving machine works? Dingli wood shaving machine is a device that automatically crushes and processes wood into wood chips. After the raw materials enter from the feed port, they are first cut by the blade and enter the crushing chamber. They are crushed by the impact of the high-speed rotating hammer and the action of the shear knife. Then, the wind generated by the built-in fan blades is sent out through the screen or the external distributor. The size of the wood chips is determined by adjusting the length of the blade and the size of the screen aperture, which has been adapted to various needs.

Solutions to faults:

(1) The belt of the wood shaving machine is easy to bite when using it. The reason is that the motor rotor and the wood shaving machine rotor are not concentric. The position of the motor can be moved left or right, or a pad can be added under the motor foot to adjust the concentricity of the two rotors.

(2) The output of the wood shaving machine is relatively low. Reason: The blade is not sharp or the blade is not adjusted to the appropriate position. Solution: Remove the blade, sharpen the blade, and adjust the blade to the appropriate chip position.

(3) Feeding is difficult and the knife has difficulty in cutting chips. Reason: The knife is severely worn and the gap of the fixed knife is too large or too small. Solution: Grind the blade to ensure that the blade is sharp. Adjust the gap of the fixed knife to 2-3mm, and the blade angle cannot be greater than 30°.

(4) The machine freezes due to too fast feeding. Reason: The feeding speed is uneven and the blade is not sharp. Solution: Feed evenly to ensure that there is no material in the crushing bin. Grind the blade to speed up the knife cutting speed.

(5) The bearing is hot. Reason: There is no grease in the bearing seat, the bearing seat is not leveled, and the bearing is damaged. The belt is installed too tight. Solution: Add grease to the bearing, balance the bearing seat, replace the new bearing, adjust the belt tightness, and make the equipment work normally.