Biomass pellets produced by sawdust pellet mill may have cracks on surface. Sometimes, sawdust pellet mill has relatively high powder rate and low output. Reason for the above failures is mostly the poor molding temperature. Slower the molding temperature, poorer the effect for raw materials to be cured. Therefore, it is necessary to improve the molding temperature and increase the steam content.



Low output of sawdust pellet machine can also be caused by the improper site of blades. Coupled with the blunt feature of blades, biomass pellets are more likely to be hit but not cut. Sometimes, you will blame that the surface of biomass pellets is not so smooth. Reason for causing that is the small compression ratio.

As long as you improve the compression ratio, surface of biomass pellets will be smooth as before. If surface of biomass pellets is smooth while the hardness is excessively high, you should lower the compression ratio properly. If water content in raw material is too high, output of sawdust pellet mill will be quite low. What’s worse, sawdust pellet mill will be often blocked.

You should blame this failure to the inefficient work of reducing valve or trap. Based on that, you should adjust the reducing valve and make steam pressure in modulator be controlled at 0.1MPa to 0.4MPa. Correspondingly, you can increase the molding temperature. Higher the molding temperature, greater the effect for raw materials to be cured.

If length of biomass pellets is not unitive, you should properly adjust the sites of blades and scrapper.

 Zhengzhou Dingli attaches more importance to the technology development and innovation. We have professional R&D center which works on technology development and innovation. The patent certificates is an honor for our company, an affirmation for technicians and also the proof of our company’s strength. Under the fierce market competition, the innovation is essential. Zhengzhou Dingli will make full use of our leading advantages in the relative field and produce high-quality equipment for clients.Customers are welcome to visit dingli company and order our products.